Inverter factory SGN-7kw 8kw 9kw 10kw 96/192V 10-60A 7000W Pure Sine Wave Inverter with AC Charger Single Phase Solar inverter

1 High load capacity
2. Quiet and efficient operation
3. Front panel LED indicator light and adjustable switch selector
4. Optional settings include lead-acid batteries, gel batteries, or glass fiber separator (AGM) batteries
5. Three stage charging (high current charging, absorption, and float charging) to improve performance
6.70A automatic 3-stage battery charger
7. Backup power supply for fast switch (grid to battery and battery grid)
The lower idle current (less than 1 watt) of 8 can be consistent with the engine, saving energy without load
9. Protection circuit for low battery, overload, high battery, and high temperature
10. Durable lifespan under extreme environmental conditions
11. High overload capacity can bear relatively large loads, and can stably handle circuit board coatings under overload conditions, which can protect them from corrosion and improve their service life and reliability
12. Durable powder coating, corrosion-resistant steel chassis, with waterproof function
matters needing attention
1) The use environment of UPS should be well ventilated, conducive to heat dissipation, and maintain a clean environment.
2) Do not carry emotional loads, such as cash registers, fluorescent lights, air conditioning, etc., to avoid damage.
3) The optimal output load control of UPS is around 60%, with the highest reliability.
4) UPS carrying too light a load (such as a 1000VA UPS carrying a 100VA load) may cause deep discharge of the battery, which will reduce its service life and should be avoided as much as possible.
5) Proper discharge can help activate the battery. If the power supply is not stopped for a long time, the UPS should be manually cut off and discharged with load every three months, which can extend the service life of the battery.
6) For most small UPS systems, when turning on the UPS after work, it is important to avoid starting it with load and turn off the UPS after work; For the UPS in the network room, as most networks work 24 hours a day, the UPS must also operate 24/7.
7) UPS should be charged promptly after discharge to avoid battery damage due to excessive self discharge.